Upstream 10-75 Ultraviolet Water System by UV Pure
Upstream 10-75 ultraviolet water system is ideal for use in homes, cottages, or businesses especially when drinking water comes from a drilled well or other high-clarity water source. It will purify 10 gallons per minute.
In The Box
Everything that comes with this product.
- UV System
- 2 X Stainless Steel Flexible Connectors
- 1 Set of Lamps
Tech Specs
Everything you need to know about this product:
- Install Location: Point of Entry
- Flow Rate: 10 US Gallons per Minute
- Plumbing: 1 Female NPT (when connectors used)"
- Required Accessories: 5 Micron Pre-Filter
- Regular Maintenance: Annual Lamp Replacements
- Electrical Requirements: 110V Standard
- Physical Dimensions: 31.5 X 8" X 8.5""
More About the Upstream 10-75 Ultraviolet Water System by UV Pure
The Upstream 10-75 ultraviolet water filter system incorporates the unique Crossfire technology where water passes inside of a quartz sleeve and two UV lamps in air - one on either side of the quartz sleeve - bathe the water in germicidal UV light killing bacteria and cysts. As with all UV Pure Ultraviolet Systems, the Upstream 10-75 is equipped with a self cleaning device which keeps the quartz sleeve clean even in very hard water conditions. You do not need to use a water softener with a UV Pure system.
Two UV sensors monitor the amount of UV being delivered to the water in real time. These sensors are monitored by an onboard microprocessor. In the event that insufficient UV light is being delivered to the water or if the water quality is too low, the microprocessor will trigger an audible and visual alarm. These alarm codes will also be displayed on the optional Remote Alarm if it is installed. The Upstream 10-75 can be used with an optional solenoid valve. The solenoid valve will close if the UV system goes into alarm, or if the power goes out. This prevents any untreated water from entering the drinking water system.
Upstream 10-75 Facts:
- must be used with a 5-micron prefilter
- can't be used on cloudy or stained water
- iron should be no greater than 3 ppm
- hardness should be less than 50 gpg
- manganese should be less than 0.5 ppm













